Products for USB Sensing and Control

Products for USB Sensing and Control

PHIDGETS Inc.

Unit 1 - 6115 4 St SE
Calgary AB  T2H 2H9
Canada
+1 403 282-7335

35mm Single Ended Output Shaft for Series 90 Worm Gearbox (Long)

ID: TRM4014_0

$13.70

Quantity Available: 51

Qty Price
5 $13.15
10 $12.60

35mm single ended shaft for series 90 worm gearboxes. W/ keyway and keys included as well as a pair of washers and a snap ring for retention in the gearbox.

Product Specifications

Physical Properties
Diameter 35 mm
Gearbox Series 90

Worm Gearboxes

This shaft is designed to fit into a worm gearbox and act as an output shaft. You can install it by following these steps:

  • Put the keys into the keyways on the shaft.
  • Slide the long end of the shaft through the gearbox.
  • The long end of the shaft should stick out the other end of the gearbox; slide the washer onto that end.
  • Put the snap ring on after the washer (There is a groove at the end of the shaft for the ring to rest inside).
Product Gearbox Properties
Image Part Number Price Gearbox Series Gear Ratio Maximum Strength of Gears Input Shaft Diameter
TRM4405_0 $203.50 90 30:1 418 N·m 24 mm

Shaft Couplers

If you need to connect this shaft to a motor or another device with a shaft, you can use a shaft coupler:

Product Physical Properties
Image Part Number Price Inner Diameter Coupling Rated Torque Coupling Rated Speed
TRM4331_0 $14.80 35 mm 3.3 Mg·cm 4000 RPM
Product Physical Properties
Image Part Number Price Gearbox Series
TRM4014_0 $13.70 90
TRM4015_0 $14.80 90