Products for USB Sensing and Control
This kit contains everything you need to get started building with PG30 T-Slot.
This is the base component for the T-Slot system. Build it into a structure using PG30 hardware.
This anchor connects two PG30 T-Slot profiles together. Swivels to allow for non-right angle connections.
This bracket reinforces a 90° joint between two PG30 profiles.
This bracket reinforces a 90° joint between two PG30 profiles. The extra length provides better strength.
This bracket reinforces a 90° joint between two double-wide PG30 profiles.
This is the strongest method for connecting two PG30 extrusions at right angles.
Cleanly connect three PG30 profiles at a cubic right angle corner.
Cap off the end of your double-width PG30 T-Slot profile.
Connect two PG30 profiles at right angles by sliding these brackets into the groove of the profile.
Connect two PG30 profiles at right angles by sliding these brackets into the groove of the profile.
Join two PG30 T-slot profiles into a longer one with these bar connectors. For more strength, use two or four on one joint.
M5 nut for bolting flat along PG30 T-Slot profiles.
M6 nut for bolting flat along PG30 T-Slot profiles.
The simplest 90° connection for PG30 profiles.
M5 nut for bolting flat along PG30 T-Slot profiles. Good for large projects that need many connection points.
M6 nut for bolting flat along PG30 T-Slot profiles. Good for large projects that need many connection points.
M5 nut for bolting flat along PG30 T-Slot profiles when the ends are no longer accessible.
Use these covers to give a cleaner look to your PG30 T-Slot profiles whose slots aren't being used.
