Products for USB Sensing and Control

Products for USB Sensing and Control

PHIDGETS Inc.

Unit 1 - 6115 4 St SE
Calgary AB  T2H 2H9
Canada
+1 403 282-7335

35mm Double Ended Output Shaft for Series 75 Worm Gearbox

ID: TRM4013_0

This double ended gearshaft allows you to mount something on either end of a series 75 worm gearbox.

$10.75

Quantity Available: 50

Qty Price
5 $10.32
10 $9.89

35mm single ended shaft for series 75 worm gearboxes. W/ keyway and keys included as well as a pair of washers and snap rings for retention in the gearbox.

Product Specifications

Physical Properties
Diameter 35 mm
Gearbox Series 75

Worm Gearboxes

This shaft is designed to fit into a worm gearbox and act as an output shaft. You can install it by following these steps:

  • Put the keys into the keyways on the shaft.
  • Slide the shaft through the gearbox until it's centered inside.
  • Slide washers onto both ends of the shaft.
  • Put snap rings onto both ends of the shaft so that the washer is between the snap ring and the gearbox (There is a groove at the end of the shaft for the ring to rest inside).
Product Gearbox Properties
Image Part Number Price Gearbox Series Gear Ratio Maximum Strength of Gears Input Shaft Diameter
TRM4404_0 $155.40 75 30:1 234 N·m 24 mm

Shaft Couplers

If you need to connect this shaft to a motor or another device with a shaft, you can use a shaft coupler:

Product Physical Properties
Image Part Number Price Inner Diameter Coupling Rated Torque Coupling Rated Speed
TRM4331_0 $14.80 35 mm 3.3 Mg·cm 4000 RPM
Product Physical Properties
Image Part Number Price Gearbox Series
TRM4012_0 $9.65 75
TRM4013_0 $10.75 75