Products for USB Sensing and Control
Replaced by the 3320_0, the same motor with a rear shaft and encoder mounting holes.
This is a nice, small, efficient stepper motor with good torque characteristics.
| Motor Properties | |
|---|---|
| Motor Type | Bipolar Stepper |
| Manufacturer Part Number | 28BYGH102 |
| Step Angle | 1.8° |
| Step Accuracy | 5 % |
| Holding Torque | 600 g·cm |
| Rated Torque | 520 g·cm |
| Maximum Speed (w/1063 Motor Controller) | 600 RPM |
| Maximum Motor Speed | 4688 RPM |
| Acceleration at Max Speed (w/1067 Motor Controller) |
2E+06 1⁄16 steps/sec² |
| Electrical Properties | |
| Recommended Voltage | 12 V DC |
| Rated Current | 670 mA |
| Coil Resistance | 5.6 Ω |
| Phase Inductance | 3.4 mH |
| Physical Properties | |
| Shaft Diameter | 5 mm |
| Mounting Plate Size | NEMA - 11 |
| Weight | 107 g |
| Number of Leads | 4 |
| Wire Length | 300 mm |
| Customs Information | |
| Canadian HS Export Code | 8501.10.00 |
| American HTS Import Code | 8501.10.40.60 |
| Country of Origin | CN (China) |
The 3300 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following diagram shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
|
Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller. |
The mounting holes on this motor are compatible with the 3337 - Mounting Bracket (NEMA11).
