Quantity Available: 99
Both ends of a ball screw need to be supported by a bearing. This bearing is used on the drive end of the screw. The nut that is included is used to secure the bearing in place on the screw. There is a set screw in the nut but this is only recommended for permanent installations as this will permanently deform the threads on the ball screw and seal the nut in place. For more temporary solutions you can use a thread locking fluid like Loctite (we recommend blue). This bearing is for 25mm ball screws.
Here is an example of a ball screw assembly.
This drive bearing is designed to fit onto the drive end of the following ball screws: