Alert.png

Notice: This page contains information for the legacy Phidget21 Library. Phidget21 does not support VINT Phidgets, and will not support any new Phidgets. Phidget21 will be maintained until 2020. We recommend that new projects be developed against the Phidget22 Library.


Click on the 2phidget22.jpg button in the menu bar to go to the Phidget22 version of this page.

Alert.png

3618 User Guide

From Phidgets Legacy Support
Revision as of 14:35, 9 May 2018 by Mparadis (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
3618.jpg
Go to this device's product page



Introduction

This manual describes how to connect and control the 3618 LED module using Phidgets I/O boards and relays.

I/O Boards:

Relays:

Connecting the LED Module

Connecting to the 1012 - PhidgetInterfaceKit 0/16/16

3618 0 Connecting 1012.jpg

  1. Connect the ground (-) wire from your power supply to the ground terminal (G) on the 1012.
  2. Connect the black anode wire from the LED module to the power supply live wire (+).
  3. Connect the red, blue, and green cathode wires from the RGB module to digital output terminals.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1012.jpg

Connecting to the 1014 - PhidgetInterfaceKit 0/0/4

3618 0 Connecting 1014.jpg

  1. Connect the black anode wire from the LED module to the power supply live wire (+).
  2. Connect the ground (-) wire from your power supply to a Common terminal on the 1014.
  3. Connect the Red, Green and Blue cathode wires from the LED module to the NO (Normally Open) terminals on the 1014.
  4. Insert jumpers between the common terminals.

If you connect the power supply live wire to the NC (Normally Closed) terminal, the LED strip will be ON when the switch is off.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1014.jpg

Connecting to the 1017 - PhidgetInterfaceKit 0/0/8

3618 0 Connecting 1017.jpg

  1. Connect the black anode wire from the LED module to the power supply live wire (+).
  2. Connect the ground (-) wire from your power supply to a Common terminal on the 1017.
  3. Connect the Red, Green and Blue cathode wires from the LED module to the NO (Normally Open) terminals on the 1017.
  4. Insert jumpers between the common terminals.If you connect the power supply live wire to the NC (Normally Closed) terminal, the LED strip will be ON when the switch is off.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1017.jpg