3531 User Guide

From Phidgets Support
Jump to: navigation, search


3531.jpg
Go to this device's product page


Getting Started

Checking the Contents

You should have received:

  • Plastic encoder cap and base
  • Encoder disk
  • Encoder PCB
  • Two screws
  • 0.9mm hex key for disk set-screw
  • 3035 - Cable for HKT22 Encoder

In order to test your new Phidget you will also need:

  • A motor with a rear shaft and compatible mounting holes
  • A motor controller Phidget
  • A Phidget with an encoder input

Connecting the Pieces

Take the plastic base, the encoder PCB, and the two screws (the screws should be inside the encoder cap). Place the PCB with the white connector facing downward so that it fits into the space on the plastic base. Take care not to touch the optical sensor on top of the PCB, because your fingerprints could affect the operation of the sensor. Place the screws in the two holes in the PCB.

3531 0 Connection1.jpg

Line the parts up with the mounting holes on the back of the motor. It doesn't matter which way the encoder is facing, but for cable management purposes you may want to have the connector facing the same direction as the motor's wires. Screw the parts onto the back of the motor, tightening until there is no visible gap between the PCB and the plastic base. Do not over-tighten.

3531 0 Connection2.jpg

Get the encoder disk and hex key. Do not touch the surface of the encoder disk, as your fingerprints could affect the operation of the optical sensor. Place the encoder disk on the rear shaft of the motor with the metal coupler facing outward. Slide the encoder disk until the surface of the disk is approximately 1.5mm from the optical sensor on the PCB. Use the hex key to tighten the set-screw on the coupler of the encoder disk.

3531 0 Connection3.jpg

Double check everything before attaching the plastic cap; it is very difficult to remove once it snaps in place.

3531 0 Connection4.jpg

Attach the included encoder cable and you're all done! For further instructions, visit the user guide for the motor controller and encoder interface Phidget that you're using.

3531 0 Connection5.jpg