Phidget Interface issue

Comments & issues
Fresh meat
Posts: 1
Joined: Wed Jul 18, 2018 3:02 am

Phidget Interface issue

Postby c_h_r_i_s » Wed Jul 18, 2018 3:12 am

Hi all,

I have a Phidget Interface Kit 0/16/16 which has 2 photo-electric sensors connected to it. Everything was working fine for a while but suddenly there seems to be an issue with both sensors communicating with the board. When I open the Phidget Control Panel I see the board and the list of digital inputs. When I click on a digital input I see the following message:

Phidget Info

Attached: Nothing

The LEDs on the board still light up when the sensors are triggered so it's obviously getting a signal in but the digital input port does not seem to recognise that the sensor is connected.

Does anyone have any idea what the issue could be?

The PC/Phidget/USB cable/sensors have not been altered since it was running so it seems odd that it would just stop working.

User avatar
Site Admin
Posts: 726
Joined: Fri Oct 28, 2011 12:17 pm

Re: Phidget Interface issue

Postby mparadis » Wed Jul 18, 2018 7:53 am

When a Phidget is visible in the control panel but cannot be attached, the most common reasons are:

- The Phidget it still open in another program or process. Unless it's being opened remotely, a Phidget can only be open in one program at a time. Try closing any programs and processes that might have been using the Phidget. You can also try plugging the Phidget into a different computer, since it shouldn't be running any programs that are using the Phidget.

- There is insufficient power on the USB hub. This is usually only a problem for single board computers such as the Raspberry Pi. This can be fixed by using a powered external USB hub.

- If the board has been damaged electrically, it is possible for it to show up but be unable to attach.

Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests