Notice: This page contains information for the legacy Phidget21 Library. Phidget21 does not support VINT Phidgets, and will not support any new Phidgets. Phidget21 will be maintained until 2020. We recommend that new projects be developed against the Phidget22 Library.
Difference between revisions of "SBC2 USB Hub Fix"
|Line 9:||Line 9:|
Latest revision as of 15:35, 18 September 2017
There is a problem on SBC2's purchased before Jan. 10th 2012. There was an issue with some of the routing to the USB hub which can cause issues with certain devices connected to the hub. Symptoms of this problem include unusual behaviour with devices connected to the USB hub such as devices detaching and attaching as well as the occasional complete failure to attach. Particularly bad offenders are servo controllers. There are 2 solutions to this problem, you can either contact us and send the device in for modification. Or you can make the modifications yourself provided you have the equipment and the ability to solder small components.
What you will need
If you intend to make the modifications yourself you will need a fine tip soldering iron, a microscope (or very sharp eyes), and a capacitor. The capacitor that needs to be added is as follows:
They can be purchased from Digikey for $0.13 a piece.
What you need to do
The capacitor needs to be added to the board in the location highlighted in red in the images that follow: