Search results

...hange trigger and/or data interval value by dragging the sliders. For more information on these settings, see the [[Data_Rate_and_Change_Trigger|data interval/cha For more information on the analog inputs on the 1065, check the [[Analog Input Guide]].

..., Ki, and Kd in order to change the behavior of the control loop. For more information on how each of these three tuning parameters affect the control loop, see � ...ther unit (degrees, for example), you can set the rescale factor. For more information on choosing the correct rescale factor, see “Setting the Rescale Factor�

{{UGC-Entry|Voltage Ratio: |Measures the "Analog In" port (Intended for feedback potentiometers that some motors have)| ..., Ki, and Kd in order to change the behavior of the control loop. For more information on how each of these three tuning parameters affect the control loop, see �

...lled as (+). There are two power supply connections available on the 1062 for each motor - either can be used. Disconnect the power from the board and co ...clockwise rotation for increasing position and counter-clockwise rotation for decreasing position, and the other will produce the opposite rotation.