ifKit dropping out

Technical Discussions on any InterfaceKits
Post Reply
berkinet
Phidget Mastermind
Posts: 212
Joined: Thu Sep 17, 2009 12:17 pm
Contact:

ifKit dropping out

Post by berkinet »

I have a 1203 ifKit (without the display) that has started to exhibit it an odd behavior. At times, when I turn on a digital output the ifKit just drops off line for a second, and then comes back, with all I/O reset. It is hooked up to a RaspberryPi and on the Pi I can see the the USB port disconnect and reconnect...

Code: Select all

Jan 10 17:34:08 CasaMilagro-Poulailler kernel: [  148.722214] usb 1-1.5.4: reset low-speed USB device number 23 using dwc_otg
Jan 10 17:34:10 CasaMilagro-Poulailler kernel: [  150.682300] usb 1-1.5.4: reset low-speed USB device number 23 using dwc_otg
Jan 10 17:34:12 CasaMilagro-Poulailler kernel: [  153.328802] usb 1-1.5-port4: disabled by hub (EMI?), re-enabling...
Jan 10 17:34:12 CasaMilagro-Poulailler kernel: [  153.329184] usb 1-1.5.4: USB disconnect, device number 23
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.632410] usb 1-1.5.4: new low-speed USB device number 24 using dwc_otg
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.772457] usb 1-1.5.4: New USB device found, idVendor=06c2, idProduct=007d, bcdDevice= 1.17
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.772476] usb 1-1.5.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.772489] usb 1-1.5.4: Product: PhidgetTextLCD 8/8/8
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.772498] usb 1-1.5.4: Manufacturer: Phidgets Inc.
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.772508] usb 1-1.5.4: SerialNumber: 67356
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.778911] hid-generic 0003:06C2:007D.0025: hiddev96,hidraw0: USB HID v1.10 Device [Phidgets Inc. PhidgetTextLCD 8/8/8] on usb-3f980000.usb-1.5.4/input0
Jan 10 17:34:13 CasaMilagro-Poulailler kernel: [  153.799913] hid-generic 0003:06C2:007D.0026: hiddev97,hidraw1: USB HID v1.10 Device [Phidgets Inc. PhidgetTextLCD 8/8/8] on usb-3f980000.usb-1.5.4/input1
Jan 10 17:34:13 CasaMilagro-Poulailler mtp-probe: checking bus 1, device 24: "/sys/devices/platform/soc/3f980000.usb/usb1/1-1/1-1.5/1-1.5.4"
Jan 10 17:34:13 CasaMilagro-Poulailler mtp-probe: bus: 1, device: 24 was not an MTP device
My guess is this is being caused by a power issue. But, the ifKit is connected to the Pi by a USB hub and is not being powered by the Pi. There are three sensors connected to analog ports: humidity, light and temperature. No other outputs are enabled when this problem happens and it only happens when an output is enabled.

Any ideas?
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests