Circular Touch hole drilling

Comments & issues
Lincon
Fresh meat
Posts: 4
Joined: Wed Jun 26, 2019 5:10 am

Circular Touch hole drilling

Postby Lincon » Wed Oct 16, 2019 2:32 pm

Hello everyone,,,
I have a question regarding the Phidget Circular touch, I know from the looks of the product that you could completely remove the very center of it where there are no components, but there where the 8 areas are for touching, could you drill a small hole in the center of it without destroying it? (1-5mm diameter)

Lincon.

User avatar
mparadis
Site Admin
Posts: 715
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: Circular Touch hole drilling

Postby mparadis » Thu Oct 17, 2019 1:25 pm

It should be fine to drill a small hole in the middle of the board where there are no components or touch regions.

(Note: we do not recommend this for higher powered Phidgets e.g. motor controllers)


Return to “General”

Who is online

Users browsing this forum: No registered users and 10 guests