Hi Phidget team!

I have repaired it and its working again. Replaced U1, the FET mentioned above, which is a very sensitive ESD Device.

Thanks for all and best regards,

Ed

Thanks Fraser,

Was thinking too about the conensator and the resistant that might not be damaged.

I have ordered the mentioned components. Hope this will repair the boards.

Best regards,
Ed

Board

Hi again. Thanks for your fast reply. I think I have found out what caused this catastrophy. Statical electricity. Just some hours ago, I returned one of the boards to my vendor. He gave me a replacement board and all went fine. I was sitting on my chair, stood up to mount it into my simulator and t...

Again thanks for your patience and great service. I found out that the relayboards are damaged. I have just bought a new dual relayboard to test. This new board works on both relays. With the same configuration, I tested the three other boards. One of them is dead on both relays. From the other two ...

Hello again

Sorry, but all black connectors were already for each dual relayboard connected. Still no change. Aint there no other way to connect a extern 5V? And perhaps this will say you anything more; from all 5 boards, only one relay is functioning.

Thanks again,
Ed

Thanks again!
Will give it a try.

Ed

Hi Thanks!

Do I have to supply 5V to the 1018 8x8x8 board?

Regards,
Ed

Hi there, Happy with Phidgets relayboards. Use 5 of them within my simulator. However I was wondering what the 0/1 control wire means/does. In the manual there is only speaking about using the control 1. I was always thinking that control 0 and 1 were corresponding to relay 1 and 2. But from the 5 d...