Newbie using spatials 1044 and 1056

Supporting Labview 2012 and up
Fresh meat
Posts: 1
Joined: Fri Nov 29, 2013 5:15 am

Newbie using spatials 1044 and 1056

Postby crusherz » Fri Nov 29, 2013 5:23 am

Hello everyone,

I've build a VI based on spatial example VI to adquire data from the spatial sensors 1044 or 1056. The VI works fine for just one sensor, but when copy and paste all the block diagram into the same VI (to adquire the data from the 2 sensors), I can only get data from one sensor.

I've tried to put all in the same loop and in different loops, but it seems that's not the problem.
Can anyone help me?

Best Regards,

Ivo Silva

Return to “Labview”

Who is online

Users browsing this forum: No registered users and 1 guest