Pressure Mapping & Interfacing in Labview via Phidget 8/8/8

Supporting Labview 2012 and up
Nihit Giri
Fresh meat
Posts: 1
Joined: Sat Oct 08, 2011 4:05 am
Contact:

Pressure Mapping & Interfacing in Labview via Phidget 8/8/8

Postby Nihit Giri » Sat Oct 08, 2011 4:25 am

Hi

I am working on a project that inputs pressure data via 5 Force Sensing Resistors (FSRs) as Analog Inputs using a Phidget 8/8/8. The Phidget is interfaced using LabVIEW.

I further want to pictorially represent Real-time pressure data.

Though I have the Phidget Manual for LabVIEW, I am clueless where to start from.

I don't know how to interface it and Map the pressure data.

Please guide.

-Nihit

Fakethatrolex
Fresh meat
Posts: 1
Joined: Thu Apr 26, 2012 11:23 am
Contact:

Re: Pressure Mapping & Interfacing in Labview via Phidget 8/

Postby Fakethatrolex » Thu Apr 26, 2012 11:25 am

Bump.

A reply to this post would be extremely helpful as I'm doing a very similar project and we are also stuck on this exact same issue. Any response would be helpful, thank you.

mtempley
Phidgetsian
Posts: 6
Joined: Fri Jan 06, 2012 5:48 am
Contact:

Re: Pressure Mapping & Interfacing in Labview via Phidget 8/

Postby mtempley » Thu May 03, 2012 11:26 am

Have either/ both of you looked at the sensor to output example provided by phidget? That's how I'm getting RT data from the analog inputs, except that I have the main state diagram running multiple times to be able to show all the channels at once. From there it is relatively simple to unbundle the display cluster and send the numeric value to a graph/ chart/ file.

Feel free to ask questions if I've assumed too much prior knowledge.


Return to “Labview”

Who is online

Users browsing this forum: No registered users and 0 guests