1057_2B Encoder not firing PositionChange event

Supporting Visual Studio on Windows
Post Reply
Abulafia
Fresh meat
Posts: 1
Joined: Tue Jul 28, 2020 1:25 pm
Contact:

1057_2B Encoder not firing PositionChange event

Post by Abulafia »

Hello all,
I am using the 1057_2B HighSpeed Encoder.
Now I have the problem that the PositionChange event is only fired once after startup but not anymore after that.
Has anyone had the same problem?
It maybe that this is related to the time where I added a VINT hub, but I am not sure.
Thanks in advance....
User avatar
mparadis
Site Admin
Posts: 959
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: 1057_2B Encoder not firing PositionChange event

Post by mparadis »

- Do you see the same problem if you use the Phidget control panel instead of your own program?

- Do you see the same problem if you disconnect all other Phidgets from the computer?

- If you have a multimeter, you can check to make sure the A and B channel wires on your encoder are changing as your encoder slowly rotates (put the probes on the exposed pins on the back of the 1057 encoder connector)
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest