Page 1 of 1


Posted: Thu Jun 14, 2018 4:56 am
by Ruchi
HI all,

I am very new to using Relay and phidget board.
I am facing one below mentioned issue with the usage of board:

1. am trying to activate relay 0 and relay 1 from the board one by one,but unable to do so.
For example:
1. I turned ON the relay 0 using phidget control panel.
2. Then i try to turn on the Relay 1, but it truns OFF the relay 0 rather turning ON the relay 1 as well.

Can you please let me know how to make 2 relays to be activated at the same time on the board i am using.Attaching the image of the board i am using.

Thanks in advance :) !!

Re: Phidget21

Posted: Thu Jun 14, 2018 7:27 am
by fraser
Which relay device are you using?

Re: Phidget21

Posted: Fri Jun 15, 2018 1:55 pm
by Patrick
This is probably a voltage dropout issue causing the board to reset. try a shorter / thicker cable, and try connecting directly to the PC, or using a powered hub.