Comments & issues
Patrick
Lead Developer
Posts: 614 Joined: Mon Jun 20, 2005 8:46 amLocation: Canada
Contact:
Post
by Patrick Fri Dec 16, 2016 2:28 pm
From the log it looks like there are 2 detaches happening - are the 1012 and 1067 both detaching at the same time?
Meijin
Phidgetsian
Posts: 12 Joined: Mon Mar 30, 2015 10:21 am
Contact:
Post
by Meijin Fri Dec 16, 2016 9:39 pm
I'm not sure I didn't think they both were but I will check on Monday. Thanks for the quick help!
Meijin
Phidgetsian
Posts: 12 Joined: Mon Mar 30, 2015 10:21 am
Contact:
Post
by Meijin Mon Dec 19, 2016 2:56 pm
I installed event ghost and did some testing.
Meijin
Phidgetsian
Posts: 12 Joined: Mon Mar 30, 2015 10:21 am
Contact:
Post
by Meijin Mon Dec 19, 2016 3:00 pm
I was not the one who wired this device, but I just checked and it looks like the diodes are missing. The ones that are shown to be across the solenoids. I was not able to get any disconnects stress testing the inputs, but when I toggled one of the outputs a few times with out activating any of the inputs I was able to get disconnects. How likely do you think the missing diodes are the cause?
Patrick
Lead Developer
Posts: 614 Joined: Mon Jun 20, 2005 8:46 amLocation: Canada
Contact:
Post
by Patrick Tue Dec 20, 2016 9:11 pm
If 1067 is disconnecting as well, it's EMI. Maybe wiring with usb cables tightly zip-tied in? Installing the diodes might help a little.
Meijin
Phidgetsian
Posts: 12 Joined: Mon Mar 30, 2015 10:21 am
Contact:
Post
by Meijin Wed Jan 18, 2017 9:13 am
So I ended up ditching the USB hub and connected the phidgets directly to the computer. (Originally I had the hub so that I only had one USB cord to route out of the control box.) For the past couple of days I haven't any sporadic detaches. Before this I had tried three different hubs and with each one I got detaches. So it looks like there was some weird interaction between the hubs and the computer.
Users browsing this forum: No registered users and 36 guests
