switch between POE supplies

Technical Discussions on any InterfaceKits
Phaneendra
Fresh meat
Posts: 1
Joined: Tue May 03, 2016 6:01 am
Contact:

switch between POE supplies

Postby Phaneendra » Tue May 03, 2016 6:07 am

Hi,

I have a device which is powered by POE switch.
There are multiple suppliers of POE switch.

i want to switch the POE supply from switch A to B at run-time to my device?

is there any way to perform this using Phidgets ?

thanks,
Phaneendra

User avatar
mparadis
Site Admin
Posts: 632
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: switch between POE supplies

Postby mparadis » Tue May 03, 2016 9:41 am

You could switch between two power supplies using the 3051 Relay Phidget. You would connect the positive wires of both power supplies to your device's power terminal, and one of each of the ground lines of the supplies to the NC and NO terminals. You would use a wire to connect the C terminal to the device's ground terminal. This way, when the relay is switched one way, it will complete the circuit of one power supply, and when it's switched the other way, it will complete the circuit of the other power supply.

The relay board can be controlled by a 1018 Phidget InterfaceKit, or any device with a digital output.


Return to “InterfaceKits”

Who is online

Users browsing this forum: No registered users and 2 guests