The undead 1018 8/8/8

Technical Discussions on any InterfaceKits
Pragma
Fresh meat
Posts: 2
Joined: Fri Apr 22, 2016 8:44 am
Contact:

The undead 1018 8/8/8

Postby Pragma » Fri Apr 22, 2016 9:07 am

Hello All,

New to Phidgets here. I found an orphaned 1018 Rev 1, from a boneyard that is recognized and installed by the USB interface as an HID compliant device and a USB input device. However, the Phidget Control panel does not recognize it at all.

The Phidget control panel recognizes other devices so I know the hardware/software chain is working.

Can anyone offer any suggestions as to why this isn't working? Are there any diagnostics I could run, or is it possible to reflash the board?

Any help is appreciated.

Thx

Bob

Pragma
Fresh meat
Posts: 2
Joined: Fri Apr 22, 2016 8:44 am
Contact:

Re: The undead 1018 8/8/8

Postby Pragma » Fri Apr 22, 2016 9:50 am

Hi again,

Newbie mistake, I skidded on the learning curve.

The individual device test panel needed to be refreshed/re-selected from the Phidget main control panel.

All is well.


Return to “InterfaceKits”

Who is online

Users browsing this forum: No registered users and 2 guests