Interfacing with Sensor

Technical Discussions on any InterfaceKits
tobor

Interfacing with Sensor

Postby tobor » Thu Feb 05, 2009 11:26 am

I'm trying to interface with a rotary sensor that provides a 5V PWM output but requires 8 VDC input. Can I read the VOUT signal from this sensor with an Interface board while the VCC and GND of the sensor are connected to a seperate power supply instead of the interface board?

fitchett
Site Admin
Posts: 263
Joined: Fri Dec 05, 2003 3:45 pm
Location: Canada
Contact:

Postby fitchett » Thu Feb 05, 2009 11:44 am

You would have to share the GND between the sensor/power supply and the 888.

Chester


Return to “InterfaceKits”

Who is online

Users browsing this forum: No registered users and 1 guest