SBC2 Boot problem

[bramey27]

Hi,

The SBC2 I have appears to have a power up boot problem. Most of the time when I apply +12 volts the board will not boot. I typically wait a couple minutes. If I hit the hard reset button , it will boot most times, but not all.

Are there any known boot issue with SBC2? What is the typical boot time?

thanks

[Patrick]

Yes, we have seen this problem on occasion, you should contact support@phidgets.com for an RMA.

This is a problem with the onboard switcher - if you use a lower voltage power supply - ie. 6 V, then the problem goes away.

-Patrick