Page 1 of 1

Multiple stepper motor controller 1067?

Posted: Fri Apr 04, 2014 7:54 am
by Nono
Hello,

I am interested in the stepper motor controller 1067.
I need to control two motors and then I would need two controllers.
I need to make my own software and I use visual basic.

My question is the following, is-it possible to control two cards at the same time? From what I read I see no way to seperate the orders given to the card number 1 and 2.
Did i miss the possibility to address several card address?

Best

Re: Multiple stepper motor controller 1067?

Posted: Fri Apr 04, 2014 8:31 am
by Patrick
Yes, each Phidget has a unique serial number, which you would specify in the open call.

-Patrick

Re: Multiple stepper motor controller 1067?

Posted: Fri Apr 04, 2014 8:32 am
by Nono
Thank you for the answer.