SSH protocol issue

General PhidgetSBC Discussion.
Post Reply
manuNDL
Phidgetsian
Posts: 6
Joined: Mon May 08, 2017 5:31 pm
Contact:

SSH protocol issue

Post by manuNDL »

Hi every body!

I am running a phidget SBC for years to control my home automation.
It is a wonderful system!
Just some reset to perform every one or two month, but generally working fine.

Unfortunately, from last week, no way to connect my phidget SBC via SSH.
Reset has not been efficient this time.
I did not take time to investigate a lot, the fact is that I can reach the SBC via phidget interface, as usual, but my own Java programm (working via SSH) do not manage to.

There has been no change at all in my programm.
Does something change in the phidget SBC itself?
Did I miss an update?

Thanks for your answer.
Manu
manuNDL
Phidgetsian
Posts: 6
Joined: Mon May 08, 2017 5:31 pm
Contact:

Re: SSH protocol issue

Post by manuNDL »

Ok it seems that my internet at home is ipv6 from last week,
And my phidget SBC3 is only supporting ipv4.
I try to upgrade packages.
Maybe an upgrade to ipv6 is included.
If not, I will switch back my home internet to ipv4.
manuNDL
Phidgetsian
Posts: 6
Joined: Mon May 08, 2017 5:31 pm
Contact:

Re: SSH protocol issue

Post by manuNDL »

I’am afraid switching from ipv6 to ipv4 was not the solution.
Did any of you encountered a ssh failure with sbc3 and have any idea from where could come the issue?
User avatar
mparadis
Site Admin
Posts: 959
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: SSH protocol issue

Post by mparadis »

When you go to the SBC web interface, under Network->Settings is the SSH server enabled? Maybe something caused it to reset back to the default disabled state.
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests