2wire RTD @TMP1200 via VINT

Any hardware type questions or problems for all other Phidget devices.
haiikun
Fresh meat
Posts: 1
Joined: Thu Dec 27, 2018 6:16 pm
Contact:

2wire RTD @TMP1200 via VINT

Postby haiikun » Thu Dec 27, 2018 6:27 pm

Hi guys,
my problem seems pretty basic but nethertheless I'm stuck.
I would like to measure a 2wire / 3wire (doesn't matter at the moment) RTD sensor. Therefor I ordered a Hub0000_0 VINT USB Hub & a couple of TMP1200_0 RTD Phidgets

Starting with the two wire method I attached the two cables to RTD+ and RTD- (in my case red + blue, the other blue wire remains unconnected).

First problem:
Trying to setup in the phidget controll panel and adjusting the sensor to 2 wire, every setting remains unsaved.

Second problem
:
I always get the problem "Saturation Detected."


I hope for a pretty obvious and easy solution, as it feels to crazy (I tried mac + win though to cutout this possiblity).


Thank you for every idea / bits and pieces,
haiikun

jdecoux
Labview Developer
Posts: 73
Joined: Mon Nov 13, 2017 10:20 am
Contact:

Re: 2wire RTD @TMP1200 via VINT

Postby jdecoux » Thu Jan 03, 2019 9:59 am

1. The control panel example is designed to always open in the default state, as it is intended more as a diagnostic tool to verify the Phidget is working as intended.

2. To get measurements out of the TMP1200 in 2-wire mode, you will need to connect the EXC+ terminal to the RTD+ terminal, and the EXC- terminal to the RTD- terminal for the sensor to measure correctly.

You can check the Wiring Modes section of the TMP1200 User Guide for more informaiton about wiring the RTD.


Return to “All Other Phidgets”

Who is online

Users browsing this forum: No registered users and 1 guest