Page 1 of 1

Gear supplier for Phidget stepper motors

Posted: Thu Apr 14, 2011 4:26 am
by johnebbinghaus
I'm looking for sprocket gears Metal or plastic) to fit some Phidget steppers with shaft dia.s of 5, 6.36, and 8 millimeters. The application will use standard 112-link bicycle chains, though this could be changed. I'm in the European Union, but outside suppliers (USA?) are fine.

Re: Gear supplier for Phidget stepper motors

Posted: Fri Jun 10, 2011 3:02 am
by nikolai
johnebbinghaus wrote:I'm looking for sprocket gears Metal or plastic) to fit some Phidget steppers with shaft dia.s of 5, 6.36, and 8 millimeters. The application will use standard 112-link bicycle chains, though this could be changed. I'm in the European Union, but outside suppliers (USA?) are fine.


I am looking for the same, you have found a place where you can buy such parts?

Re: Gear supplier for Phidget stepper motors

Posted: Fri Jun 10, 2011 12:34 pm
by johnebbinghaus
Hello Nikolai, I found some at http://www.robotmarketplace.com/product ... in_25.html. The 1/4" bore should fit the 6.36mm phidgets shafts. I haven't ordered any yet though...
Hvor er du henne i Kongeriget, og hvad laver du med Phidgets?

Re: Gear supplier for Phidget stepper motors

Posted: Tue Jun 14, 2011 1:04 am
by nikolai
Many thanks, just what I searched:)

Jeg kommer fra Viborg og er igang med en selvk√łrende vogn til h√¶rvejsmarchen.

Hvad med dig, hvor i landet befinder du dig, og hvad er du ved at stykke sammen :)