Page 1 of 1

phidgets 1067 stepper motor labview vi

Posted: Tue Aug 02, 2016 1:28 am
by tamir87
Hi,

I'm operating my phidgets 1067 via labview.

There is a VI that indicates when the movement operation is done?

I can't build a series of movements because it sends the next command before the step motor finished to move..

Re: phidgets 1067 stepper motor labview vi

Posted: Tue Aug 02, 2016 7:32 am
by mparadis
You can try using StepperStoppedState.

Although it's important to note that this function defines "stopped" as "when the stepper controller is no longer driving the motor forward". This means that if the motor is still physically moving due to inertia, this function may still report the motor as "stopped".

Re: phidgets 1067 stepper motor labview vi

Posted: Thu Aug 04, 2016 3:22 am
by tamir87
mparadis wrote:You can try using StepperStoppedState.

Although it's important to note that this function defines "stopped" as "when the stepper controller is no longer driving the motor forward". This means that if the motor is still physically moving due to inertia, this function may still report the motor as "stopped".



Thank you very much!
ill consider the inertia