phidgets 1067 stepper motor labview vi

Supporting Labview 2012 and up
tamir87
Fresh meat
Posts: 2
Joined: Tue Aug 02, 2016 1:15 am
Contact:

phidgets 1067 stepper motor labview vi

Postby tamir87 » Tue Aug 02, 2016 1:28 am

Hi,

I'm operating my phidgets 1067 via labview.

There is a VI that indicates when the movement operation is done?

I can't build a series of movements because it sends the next command before the step motor finished to move..

User avatar
mparadis
Site Admin
Posts: 654
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: phidgets 1067 stepper motor labview vi

Postby mparadis » Tue Aug 02, 2016 7:32 am

You can try using StepperStoppedState.

Although it's important to note that this function defines "stopped" as "when the stepper controller is no longer driving the motor forward". This means that if the motor is still physically moving due to inertia, this function may still report the motor as "stopped".

tamir87
Fresh meat
Posts: 2
Joined: Tue Aug 02, 2016 1:15 am
Contact:

Re: phidgets 1067 stepper motor labview vi

Postby tamir87 » Thu Aug 04, 2016 3:22 am

mparadis wrote:You can try using StepperStoppedState.

Although it's important to note that this function defines "stopped" as "when the stepper controller is no longer driving the motor forward". This means that if the motor is still physically moving due to inertia, this function may still report the motor as "stopped".



Thank you very much!
ill consider the inertia


Return to “Labview”

Who is online

Users browsing this forum: No registered users and 1 guest