Error 7004 on setting stepper velocity limit, acc.

Supporting Labview 2012 and up
aro
Phidgetly
Posts: 16
Joined: Wed Oct 31, 2012 3:03 pm
Contact:

Error 7004 on setting stepper velocity limit, acc.

Postby aro » Wed Mar 19, 2014 2:44 pm

I am using stepper 3314 and board 1062 with LabView. I have created a stepper program, but whenever I try to set the velocity limit and acceleration, I get error 7004. I have attached a screenshot of the wiring of the velocity and acceleration setting stage. The program will still run, but it is not a long term solution to keep having the error pop up. I have already initialized the phidget prior to this state in my state queue.

Thanks.
Attachments
error7004.png
Error message
error7004-block diagram.png
Block diagram for setting velocity limit and acceleration

User avatar
Patrick
Lead Developer
Posts: 3052
Joined: Mon Jun 20, 2005 8:46 am
Location: Canada
Contact:

Re: Error 7004 on setting stepper velocity limit, acc.

Postby Patrick » Wed Mar 19, 2014 3:14 pm

Make sure you aren't setting out of range values. 1062 has lower maximums then other stepper controllers.

-Patrick


Return to “Labview”

Who is online

Users browsing this forum: No registered users and 1 guest