PositionChange_Handler stopped being called

Supporting 10.7 and up
qdx
Fresh meat
Posts: 1
Joined: Wed May 11, 2016 6:41 am
Contact:

PositionChange_Handler stopped being called

Postby qdx » Wed May 11, 2016 6:54 am

Hi

I'm running a stepper motor on MacOS X El Capitan/Yosemite with a Phidget controller.
I need to know when the motor has reached its position.
I've registered a function with the following CPhidgetStepper_set_OnPositionChange_Handle function.

The handler is called two or three times and after a while this function is not called anymore.

I didn't get this kind of issues before the update for the firmware and my code worked for more than two years

Did you experience this kind of issues and can we expect a fix ?

Pyshka
Fresh meat
Posts: 2
Joined: Wed Feb 17, 2016 6:54 am
Contact:

Re: PositionChange_Handler stopped being called

Postby Pyshka » Sun May 22, 2016 5:48 am

I wouldn't expect a fix...DJI is the best drone manufacturer cause they've managed to release the best drone yet - DJI Mavic Pro! Read Mavic Pro review here.
Last edited by Pyshka on Fri Aug 17, 2018 9:58 am, edited 2 times in total.

User avatar
Patrick
Lead Developer
Posts: 3064
Joined: Mon Jun 20, 2005 8:46 am
Location: Canada
Contact:

Re: PositionChange_Handler stopped being called

Postby Patrick » Tue May 24, 2016 11:39 am

This will be fixed. We are still looking into the cause.

-Patrick


Return to “macOS”

Who is online

Users browsing this forum: No registered users and 1 guest