Products for USB Sensing and Control

Products for USB Sensing and Control

PHIDGETS Inc.

Unit 1 - 6115 4 St SE
Calgary AB  T2H 2H9
Canada
+1 403 282-7335

Draw Wire Encoder (1.5m)

ID: ENC4107_0

Like a digital tape measure, this 1500mm draw wire encoder measures the length of wire pulled out of it.

$150.00

Quantity Available: 50

Qty Price
5 $144.00
10 $138.00

In complex mechanical systems, it is often very difficult to accurately measure the movement of a single part, particularly if it has several degrees of freedom. The draw wire encoder is a versatile solution to this very problem; it can be attached to a part using an M5 screw or fastened to the end with a zip tie, and the encoder itself has a pair of M5 screw threads on the back for easy installation.

FUNCTIONAL

When the wire is pulled out, the sensor produces a quadrature signal to describe the length of wire exposed. The reel is spring loaded, so it will retract when there is no tension in the wire. Multiple draw wire sensors could be used to track the position in more than one dimension.

Product Specifications

Encoder Properties
Output Circuit Type Push-Pull
Wire Resolution 100 μm/cyc
Wire Pull Length 1.5 m
Electrical Properties
Supply Voltage Min 8 V DC
Supply Voltage Max 26 V DC
Current Consumption Max 60 mA
Physical Properties
Wire Load Maximum 255 g
Wire Pull Speed Max 1 m/s
Weight 485 g
Operating Temperature Min -30 °C
Operating Temperature Max 90 °C
Screw Thread Size M5
IP Rating IP54

Encoder Interfaces

This draw-wire encoder must be read by an encoder interface. These interfaces will interpret the two quadrature signals in order to determine the continuous position of the draw wire. The following interfaces are compatible with this encoder:

Product Encoder Interface
Image Part Number Price Number of Encoder Inputs Count Rate Max
1047_1B $75.00 4 1E+06 pulses/s
1057_2 $60.00 1 2E+06 pulses/s
1065_0 $80.00 1 500000 cycles/s
ENC1000_0 $15.00 1 400000 pulses/s

Encoder Cables

ENC4107 Red Black White Green Yellow
3019 cable Red Black White Brown Green

You can easily connect this draw-wire encoder to a Phidgets encoder interface by cutting the end off of a Phidget encoder cable and soldering the wires to the encoder as described in this table. Below you'll find a list of available encoder cables:

Product Physical Properties
Image Part Number Price Cable Length Cable Gauge
3019_0 $5.00 500 mm 26 AWG

Here are our draw wire encoders:

Product Encoder Properties Physical Properties
Image Part Number Price Output Circuit Type Wire Resolution Wire Pull Length Weight
ENC4103_0 $130.00 Push-Pull 80 μm/cyc 500 mm 300 g
ENC4104_0 $145.00 Push-Pull 80 μm/cyc 1 m 305 g
ENC4105_0 $160.00 Push-Pull 100 μm/cyc 2 m 420 g
ENC4106_0 $135.00 Push-Pull 100 μm/cyc 600 mm 255 g
ENC4107_0 $150.00 Push-Pull 100 μm/cyc 1.5 m 485 g
ENC4108_0 $165.00 Push-Pull 100 μm/cyc 2.5 m 580 g