The KTC series linear potentiometer is designed to provide position feedback for systems with moving parts. This potentiometer can extend to a length of 200mm and is protected by an anodized aluminium outer casing.
This sensor can be used with any device with an analog input. Simply cut and connect a 3-wire Phidget cable as described in the Phidget Cable section on the Compatible Products tab.
|Sensor Type||Input (Linear)|
|Controlled By||VoltageRatio Input|
|Linear Travel||200 mm|
|Potentiometer Impedance||5 kΩ|
|Repeatability Error Max||0.005 %|
|Lifespan||100 million actuations|
This potentiometer can be read by any Phidget with an Analog Input or VINT Hub port. It will connect to either one using a Phidget cable; see the diagram in the Phidget Cables section below for wiring instructions. VINT Hub ports can behave just like Analog Inputs, but have the added flexibility of being able to be used as digital inputs, digital outputs, or ports to communicate with VINT devices. For more information about VINT, see the VINT Primer.
|Image||Part Number||Price||Number of Voltage Inputs||Voltage Input Resolution|
|HUB0000_0||$30.00||6 (Shared)||* 16 bit|
|SBC3003_0||$120.00||6 (Shared)||* 16 bit|
To easily connect this potentiometer to a Phidget we recommend you use a Phidget cable. Just snip off the connector from one end of the Phidget cable, strip the ends of the wires and connect them using the screw terminals as shown in the diagram. You can solder multiple cables together in order to make even longer Phidget cables, but you should be aware of the effects of having long wires in your system.
|Image||Part Number||Price||Sensor Type||Controlled By||Linear Travel|
|1112_1||$11.00||Input (Slider)||VoltageRatio Input||60 mm|
|3579_0||$65.00||Input (Linear)||VoltageRatio Input||75 mm|
|3580_0||$75.00||Input (Linear)||VoltageRatio Input||100 mm|
|3581_0||$95.00||Input (Linear)||VoltageRatio Input||200 mm|
|3582_0||$120.00||Input (Linear)||VoltageRatio Input||300 mm|