|1032_0 - PhidgetLED-64 Advanced|
This Phidget uses current control to adjust the brightness of up to 64 LEDs.
The PhidgetLED 64 allows you to independently control 64 Light Emitting Diodes. Each LED can have the current limit set individually, and the brightness controlled from 0 to 100% within that limit using current control. These LED outputs can also be used to interface other devices that benefit from current control (such as buzzers, fans, and other small, simple electronics).
Most standard LEDs have forward voltages below 2.75 Volts, and can be used with the PhidgetLED by simply soldering them to a connector-wire and inserting the wire into any PhidgetLED board output. The forward voltage will default to 2.75V, and the maximum current defaults to 20mA.
- A 3018 - Mini-USB Cable 180cm
- 3021 - 16 Double Ended cables
- A 12VDC, 2A Power Supply
- A Hardware mounting kit (4 nuts and bolts (M3), 4 plastic spacers)
Note: Cut the Double Ended cables in half and solder the cut end to the LED. Check the Getting Started section of the User Guide for more detailed information.
|API Object Name||LED|
|Number of LED Outputs||64|
|Recommended Wire Size (Power Terminal)||12 to 26 AWG|
|Power Jack||5.5 x 2.1mm Center Positive|
|Operating Temperature Min||-40 °C|
|Operating Temperature Max||85 °C|
|Current Consumption Min||70 mA|
|Supply Voltage Min||6 V DC|
|Supply Voltage Max||15 V DC|
|Selectable Output Voltage Levels||1.7, 2.75, 3.9, 5.0 VDC|
|Output Current Limit Max||(Per LED) 80 mA|
|LED Current Limit Max||80 mA|
|LED Current Limit Resolution||1.3 mA|
|USB Speed||Full Speed|