|3304_0 - NEMA-17 Bipolar 32mm Stepper|
This high speed bipolar stepper has a 3.75° step angle and 590 g·cm of torque at low speeds.
This is our fastest Stepper Motor. It provides good torque at slightly less resolution than our other steppers.
The 3304 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following diagram shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and green wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The mounting holes on this motor are compatible with the 3338 - Mounting Bracket (NEMA17).
|Motor Type||Bipolar Stepper|
|Manufacturer Part Number||39BYGS202|
|Step Angle||3 3⁄4°|
|Step Accuracy||5 %|
|Holding Torque||750 g·cm|
|Rated Torque||590 g·cm|
|Maximum Speed (w/1063 Motor Controller)||1250 RPM|
|Maximum Speed (w/1067 Motor Controller)||4105 RPM|
|Acceleration at Max Speed |
(w/1067 Motor Controller)
|1E+06 1/16 steps/sec²|
|Recommended Voltage||12 V DC|
|Rated Current||1 A|
|Coil Resistance||4.5 Ω|
|Phase Inductance||5 mH|
|Shaft Diameter||5 mm|
|Mounting Plate Size||NEMA - 17|
|Number of Leads||4|
|Wire Length||300 mm|
|Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller.|