Products for USB Sensing and Control
It is currently Wed Apr 16, 2014 6:48 pm

All times are UTC - 7 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Dec 28, 2011 10:02 am 
Offline
Fresh meat

Joined: Wed Dec 28, 2011 9:51 am
Posts: 1
Dear Phidgets' staffs,

I am looking for a step motor/ servo, which can be controlled by MATLAB. I am not an expert about programming, and my work is not related directly about programming, so I am looking for instant program/complement. My work is collecting data of each shaft’s angle by using MATLAB. For more information, the shaft will be attached with 200-500 grams of metal, and will be rotated by a servo/ step motor. I am sure that I can do GUI part for whole system, but not implement part.

1) Is it possible to find a step motor/ servo that will come with MATLAB source code? Could you please suggest me which one/ model is fit for my work?

2) I am also looking for a Relay Board controlled by MATLAB. I found “Phidget Relay Board Interface Kit 0/0/4 USB" that will come with MATLAB source code. However, I am not sure about the version of MATLAB that has been referred to (on the website). Can you confirm that codes can operate on MATLAB version R2010-R2011?

PS. I don’t seriously mind paying for a program VS, VC, VB or whatever program/ compiler, if it can just make sure that I can operate both the servo and the relay board by using MATLAB, please suggest me.


I am looking forward to your reply.
Thank you very much.

Regards,
Chittawan.
Curtin University, Western Australia, Australia


Top
 Profile Send private message  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group